Maintenance - Dimplex 6905050100-500 Service Manual

MAINTENANCE

Light Bulb Replacement (Mod 0-A Only)
Allow at least five (5) minutes for light bulbs to cool before
touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark
section of the flame or when the clarity and detail of the
log ember bed exterior disappears. There are two 2 bulbs
under the log set, which generate the flames and embers.
Light Bulb Requirements
Quantity of two 2 clear chandelier or candelabra bulbs with
an E-12 (small) socket base, 60 Watt rating. Example: GE
60BC or Philips 60 CTC.
Do not exceed 60 Watts per bulb .
Helpful Hints
It is a good idea to replace both light bulbs at one time
if they are close to the end of their rated life. Group
replacement will reduce the number of times you need to
open the unit to replace light bulbs. Care must be taken
when removing the log set.
To Access The Lower Light Bulb Area: (Figure 3)
1. Remove front glass assembly.
2. Pull the front edge of the plastic Ember Bed, plastic
grate or Media Tray (depending on Model) up and
forward until the rear tab releases from the ledge
located at the bottom of the partially reflective glass.
! IMPORTANT: Only handle the log set by the ember bed.
! NOTE: Log set fits tightly into firebox, some force may
be necessary to remove.
3. Set Log Set/ Media Tray in front of fireplace.
4. Disconnect flicker from motor (see Figure 3).
5. Unscrew bulbs counter clockwise.
6. Insert new bulbs.
7. Reconnect flicker to motor.
8. Replace the log set by inserting the front edge of the
log set and push down on the rear edge of the ember
bed until it snaps into place (Figure 4).
! NOTE: Ensure the log set is installed tightly under the
back ledge to prevent light leakage.
9. Replace glass assembly.
4
Glass Cleaning
The front glass is cleaned in the factory during the
assembly operation. During shipment, installation,
handling, etc., the front glass may collect dust particles,
these can be removed by dusting lightly with a clean dry
cloth.
To remove fingerprints or other marks, the glass can be
cleaned with a damp cloth. The glass should be completely
dried with a lint free cloth to prevent water spots. To
prevent scratching, do not use abrasive cleaners or spray
liquids on the glass surface.
Fireplace Surface Cleaning
To remove fingerprints or other marks, the exterior finish
can be cleaned with a damp cloth with a mild detergent.
The surface should be completely dried with a lint free cloth
to prevent water spots .
Figure 3
Figure 4
Mirror
Back Ledge
Rear Tab
Side Section
Flicker
Ember Bed
Assembly
Front Edge
www.dimplex.com