Page 1
For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.com 7211120100R05...
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNINg: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric fireplace from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
IMPORTANT INSTRUCTIONS ⑭ To reduce the risk of electric ⑰ Do not strike the fireplace shock, this appliance has a glass. polarized plug (one blade is wider ⑱ Always use a certified than the other). This plug will fit in electrician should new circuits or a polarized outlet only one way.
To reduce not cause interference and (2) this the risk of fire, electric shock or device must accept any interference, injury to persons, always use a including interference that may cause licensed electrician. undesired operation of the device. www.dimplex.com...
! NOTE: The dimensions of fireplace into your Dimplex mantel the firebox are 30 inches surround. (762 mm) wide X 18 ⅞ inches select a suitable location that (479.5 mm) high X 9 ¼...
Opening on the same circuit may exceed the current rating of the circuit breaker. IMPORTANT: If not using a Dimplex mantel, the fireplace must be installed in an enclosure with the mInImum internal/ opening dimensions see Figure 1. Feet Visible Edges...
Page 9
Fireplace Installation to junction box on fireplace fireplace in a safe, dry and dust free location. when installing after finishing wall. Use studs to frame an opening of 24 ½ inches (622 CAUTION: Use two mm) wide X 18 ¼ inches conductor, non-metallic sheath (463.6 mm) high X 8 ⅞...
Ensure that the cable clamp tubs, etc. never locate fireplace grips only the jacket of where it may fall into a bathtub or service cable. other water containers. Bathroom Installation www.dimplex.com...
Fireplace Installation Front glass Installation If unit is not hard-wired, plug fireplace into a 15 Amp, 120 Carefully mount front glass Volt outlet (refer to noTE 1). assembly so that the front glass hooks (2) hang on the front glass mounts on the Figure 5 fireplace (2).
Remote Control Initialization/ CAUTION: If you need to Reprogramming continuously reset the heater, disconnect power and call In the event that your remote Dimplex customer service at control ceases to operate your www.dimplex.com...
If you are still experiencing issues with your remote control, contact Dimplex North America Limited Button Customer Service at 1-888-346- 7539, or visit the Dimplex website Button at www.dimplex.com. Battery Replacement (Figure 7) To replace the battery: Battery...
! NOTE: Ensure the log set is bulbs. Care must be taken when installed tightly under the back removing the Log Set Assembly ledge to prevent light leakage. as it contains LED’s and wires. 9. replace glass assembly. www.dimplex.com...
Page 15
Maintenance glass Cleaning Figure 8 The front glass is cleaned in Flicker rod the factory during the assembly operation. During shipment, installation, handling, etc., the front glass may collect dust particles, these can be removed by dusting lightly with a clean dry cloth.
Warranty Two Year Limited the provisions of this warranty, Dimplex warrants such products to be free from Warranty defects in material and workmanship for a period of 2 years from the date of the Products to which this limited warranty...
Page 17
30 miles (48 km) from proof of purchase of the product. the closest service depot of Dimplex’s dealer or service agent; and (ii) What Dimplex will do in the event of a the purchaser is solely responsible defect for providing clear access to all In the event a product or part covered serviceable parts of the product.
Page 18
InABILITY To usE THE ProDuCT, the first anniversary of the date of EVEn IF DImPLEX or ITs DIrECTors, first purchase, Dimplex will in its sole oFFICErs, or AGEnTs HAVE BEEn discretion either repair or replace such ADVIsED oF THE PossIBILITY oF...
Need help?
Do you have a question about the BF9000 and is the answer not in the manual?
Questions and answers