Table of Contents
Advertisement
T R O U B L E S H O O T I N G
If you suspect that your ROKSAN K2 Stereo Power Amplifier is not operating properly, you should check all the
connections carefully. Pay particular attention to speaker phasing and channel connections. Phono plugs should
be fully inserted- a frequent cause of problems is that Phono plug surrounds do not make proper contact. Below
are some commonly encountered problems with suggestions for possible cure. The list is not exhaustive: If you
have any unresolved problems, please consult your appointed ROKSAN dealer or distributor.
SYMPTOM
No power
No output on one or more
channels
Lower output on one or both
channels
Poor speaker imaging, lack
of Bass output
Hum from speakers
G U A R A N T E E
There are no user-serviceable parts inside your
your appointed ROKSAN retailer, distributor or ROKSAN approved service agent.
K2 Stereo Power Amplifier
Your ROKSAN
five years from the date of purchase.
This guarantee only becomes effective if the warranty card is validated by the ROKSAN retailer from whom the equipment
was purchased and returned to ROKSAN within 28 days of purchase.
This guarantee excludes:
1. Damage caused due to accident, missuse, neglect and incorrect installation, adjustment or repair.
2. Liability for damage or loss during transit from the retailer or purchaser to ROKSAN or its authorised distributor for the
purposes of repair or inspection.
Carriage costs to ROKSAN shall be borne by the consignor.
All claims under this guarantee must be made through an authorised ROKSAN retailer.
If equipment returned for repair to ROKSAN is found on inspection to comply with the product specification ROKSAN
reserves the right to make a charge for examination and return carriage.
Unauthorised servicing will void this guarantee.
Roksan Audio ltd
CLASSIFICATION: General Use
All specifications are liable to change without notice. E&OE
LIKELY CAUSE
AC Mains lead not inserted properly
Unit not switched on at rear panel
Missing or bad input signal connection
Incorrect speaker connection
Higher trim on one or both channels
Loudspeakers connected out of phase
Incorrect Grounding
K2 Stereo Power Amplifier
is guaranteed against any defect in materials and workmanship for a period of
Page 9 of 11
K
2
Stereo Power Amplifier
K
2
K
2
SUGGESTED REMEDY
Ensure AC Mains lead is fully inserted
Switch unit on at rear panel
Check all input connections
Check speaker output connections on
rear panel
Check trim level and adjust accordingly
Check polarity of speaker connections
(especially important if Multi-wiring,
Multi-amping)
Check Mains polarity and grounding on
all connected equipment
K
2
Stereo Power Amplifier
K
2
K
2
. If a fault should develop; refer all servicing to
K2 Stereo Power Amplifier User Manual
Version 1.02
ENGLISH
Advertisement
Table of Contents
