Hitch and trailer
Hitch
Introduction
This chapter contains information on the following subjects:
Description
Adjusting the ready position
A correctly set ready position
Assembling the bar ball - 1. Step
Assembling the bar ball - 2. Step
Check proper fitting
Removing the bar ball - 1. Step
Removing the bar ball - 2. Step
Accessories
The maximum trailer drawbar load is 50 kg.
WARNING
Check that the tow bar is seated correctly and is secured in the mounting
■
recess before the start of every journey.
Do not use the ball head, if it is not correctly inserted into the mounting
■
recess and secured.
Do not use the towing equipment if it is damaged or incomplete.
■
Do not modify or adapt the towing device in any way.
■
Never release the tow bar while the trailer is still coupled.
■
Keep the mounting recess of the towing equipment clean at all times.
■
Such dirt prevents the ball head from being attached securely.
CAUTION
Take care with the ball bar - there is a risk of paint damage to the bumper.
■
When the tow bar is removed always place the cover onto the mounting re-
■
cess - there is a danger of soiling the mounting recess.
Note
Operation and maintenance of hitch
■
Tow the vehicle by means of the detachable ball rod
■
120
Driving
» page
135.
» page
169.
Description
120
121
121
122
122
Fig. 111 Carrier for the towing device / tow bar
123
Read and observe
123
123
The ball head can be removed and is kept in the spare wheel well or in a com-
124
partment for the spare wheel in the luggage compartment.
Support for the towing device and tow bar
Cap
1
Mounting recess
2
Protective cap
3
Locking ball
4
Centring
5
Hand wheel
6
Key
7
Lock cap
8
Red marking on the hand wheel
9
Ball head
10
Green marking on the hand wheel
11
White marking on ball head
12
Note
On the bottom of the key is a code number. If you lose a key, please contact a
specialist garage which will be able to use this code number to provide you
with a new one.
and
on page 120 first.
» Fig. 111