Hitch And Trailer; Hitch - Skoda Rapid Operating Instructions Manual

Save tyre pressure values by pressing a button

Read and observe on page 113 first.
›
Inflate all the tyres to the specified pressure.
›
Switch on the ignition.
›
Press the symbol button  » Fig. 120
The warning light in the instrument cluster illuminates.

An acoustic signal and the control indicator provide information about the
storage of the tyre pressure values.
›
Release the symbol key  .
114
Driving
Fig. 120
Key for storing the pressure val-
ues
and hold.

Hitch and trailer

Hitch


Introduction
This chapter contains information on the following subjects:
Description
Adjusting the ready position
A correctly set ready position
Assembling the bar ball - Step 1
Assembling the bar ball - Step 2
Check proper fitting
Removing the bar ball - Step 1.
Removing the bar ball - Step 2.
Mount accessories
If your vehicle has already been factory-fitted with a towing device or is fitted
with a towing device from ŠKODA Original Accessories, then it meets all of the
technical requirements and national legal provisions for towing a trailer
» page 119.
The maximum trailer draw-bar load is 50 kg.
The draw bar load information on the type plate of the towing device is merely
a test value for the towing device. The vehicle-specific information is detailed
in the vehicle documents.
WARNING
Check that the tow bar is seated correctly and is secured in the mounting
■
recess before the start of every journey.
Do not use the ball head, if it is not correctly inserted into the mounting
■
recess and secured.
Do not use the towing equipment if it is damaged or incomplete.
■
Do not modify or adapt the towing device in any way.
■
Keep the mounting recess of the towing equipment clean at all times.
■
Such dirt prevents the ball head from being attached securely.
115
115
116
116
117
117
117
118
119
