To Unload A Cd; Basics Of Using The Cd Player-Normal Play; Programming The Playing Order Of The Tracks - JVC FS-SD58V Instructions Manual

To Unload a CD

Take out the CD as shown below.
Basics of Using the
CD Player-Normal Play
To Play a CD
• The display explained here is for digital audio CDs. It
differs a little depending on the disc to be used. For
example, when a video CD is played, "VCD" will be dis-
played instead of "CD".
1
Insert a CD.
Press the CD #¥8 button.
2
The first track of the CD begins playing.
Track number
• The track number that has already played disappears
from the music calendar.
• The CD Player automatically stops when the last
track of the CD has finished playing.
To stop playing the CD, press the 7 button.
The following information for the CD is displayed.
Total track number
To stop playing and remove the CD, press the
OPEN/CLOSE button on the Unit to open the Top Cover.
To pause, press the CD #¥8 button. The playback time
blinks on the display.
To cancel pause, press the same button again. Play con-
tinues from the point where it was paused.
Playback time
Total playback time
To Select a Track or Passage within a Track
During playback, press the 4 or ¢ (DOWN or UP, or
< or >) button on the Unit or the Remote Control to select
the track you want.
• The selected track starts playing.
• Press the ¢ (UP or >) button on the Unit or the
Remote Control once to skip to the beginning of the
next track.
• Press the 4 (DOWN or <) button on the Unit or the
Remote Control to skip to the beginning of the track
being played. Press twice quickly to skip to the begin-
ning of the previous track.
• When the > or < button on the Remote Control is
kept pressing, the track continuously skips.
Search Play
Holding down the 4 or ¢ (DOWN or UP) button on
the Unit or the Remote Control, during playback, will fast
forward/backwards the CD so you can quickly find a partic-
ular passage in the track you are listening to.
Programming the
Playing Order of the Tracks
You can program the playing order of the tracks using the
Remote Control.
You can program up to 32 tracks in any desired order in-
cluding the same tracks.
You can only make a program when the CD Player is
stopped.
1
Insert a CD.
Press the CD #/8 button.
2
Press the 7 button to stop the CD.
3
4
Press the PLAY MODE button until the
"PROGRAM" indicator lights up on the
display.
Each time you press the PLAY MODE button, the dis-
play changes as follows:
CD - - P - - (Program Play) --> CD RANDOM (Ran-
dom Play) --> Normal Play --> (back to the beginning)
PLAY MODE
PROGRAM
5
Press the UP, DOWN, >, or < button to
select the track to program.
UP or > button: Increases the track number by 1.
DOWN or < button:Decreases the track number by 1.
• When the > or < button is kept pressing, the track
number changes rapidly.
(To be continued on the next page)
Using the CD Player
14