Pioneer LD-V4400 Level I User Manual page 33

On Page One:
CONTENTS
* PLAYER CONTROL SW. (Switch)
P-2
* RS-232C CONTROL SW. (Switch)
P-3
* SWITCH SETTING
P-4
On Page Two:
PLAYER CONTROL SW.
* SIDE REPEAT
Off or On
* LOAD START
Off or On
* POWER-ON START
Off or On
* SQUELCH
Blue Background
or Black Background
* TEST MODE SELECT
Off or On
On Page Three:
RS-232C CONTROL SW.
* BAUD RATE
4800, 1200 or 9600 BAUD
* TxD Terminator
<CR> or <CR> <LF>
On Page Four:
SWITCH SETTING
* Diagram of Switch Bank One and Switch Bank Two (See Figures 2-Q, R, S
on next page.)
LD-V4400 Level I & III User's Manual
LD-V4400 Level I & III • Chapter Two
P-1
P-2
When set to ON and the end of the videodisc is
reached, the player automatically returns to the
beginning of the disc and starts playing.
When set to ON and a loaded disc tray is pushed in,
playback starts automatically.
When set to ON and Power is turned on, and there is a
disc in the drawer, playback is started automatically.
Selects Blue or Black Squelch Screen seen during
PAUSE, STOP or SEARCH
This mode is usually left OFF. It is used by Service
Center personnel when servicing the player.
P-3
Sets the BAUD Rate.
Establishes the terminator as either Carriage
Return, or Carriage Return/Line Feed.
P-4
TP 116 v1.1 • 9/93
This page describes the "Contents" of
the Function Switch Setting menus. It
identifies the pages where function
settings are listed for each general
topic.
For example, the functions that
determine Player Control are found on
page 2.
2-15