Button Backlighting Adjustment; Display Backlighting Adjustment; Changing The Opening Image; Security Code Setting - Alpine iLX-700 Owner's Manual

Button Backlighting Adjustment

You can adjust the brightness of the button lighting at night with the
dimmer.
Setting item: Key Illumination Level
Setting level: -2 to +2 (Initial setting: 0)

Display Backlighting Adjustment

You can adjust the brightness of the backlight. This function could be
used, for instance, to change the screen brightness while traveling at
night.
Setting item: Screen Dimmer Level
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the level between MIN (-15) and MAX (+15).
When it reaches the minimum or maximum point, the display
shows "MIN" or "MAX" respectively.

Changing the Opening Image

You can set the image file for the opening screen. Copy your desired
image file from a USB memory device.
Setting item: Opening Customization
Setting contents: Default (Initial setting) / User
The file selected in the User mode will be copied according to the
following procedure.
1
Connect the USB memory device which contains the
BMP file to be copied to the unit.
2
After the confirmation message is displayed, touch
[OK].
The Opening image is changed.
Copiable image files
BMP
File format:
Image size: 800 × 480 pixels, RGB 24 bit or less
Folder Name: OPENINGFILE
File Name: openingfile.bmp

Security Code Setting

Setting Security code

You can set the system to be unusable without entering a password.
When you turn this setting to "On" and set a password, password input
is required when the system is connected to a battery and turned on for
the first time.
Setting item: Security Code
Setting contents: Off (Initial setting) / On
Setting the password
1
Set "Security Code" to "On".
2
After the confirmation message appears, touch
[OK].
The password setting screen is displayed.
3
Enter a password, then touch [Enter].
• Enter the 6-digit number.
• Input numbers are displayed as "*".
4
Enter the same password again, then touch [Enter].
The password is set and the system returns to the previous
screen.
• If you forget a registered password, you cannot use this unit. In this
case, service will be required.
Clearing the password
1
Set "Security Code" to "Off".
The password setting screen is displayed.
2
Enter the password you have set, then touch
[Enter].
The password is cleared and the system returns to the
previous screen.
• Input numbers are displayed as "*".
24
-EN