Dealer Calibration; User Calibration On/Off; Response Settings; Boat Show Mode - Raymarine ST60 Owner's Handbook Manual

30

4.4 Dealer Calibration

The Dealer calibration procedure (see Dealer calibration diagram)
enables the following parameters to be set:

• User calibration on/off.

• Depth response.
• Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen. This
enables you to re-apply the factory settings if you want to reset the
instrument to a known operating condition.
To commence Dealer calibration, hold down the depth and alarm
keys together for approximately 12 seconds, to select the Dealer
calibration entry page. Momentarily press the offset and reset keys
to proceed with the calibration, then use the depth key to proceed
from screen to screen as calibration progresses.
User calibration on/off
Use either the offset
or OFF as required. With OFF selected, User calibration and
Intermediate calibration are both disabled. This feature is particularly
useful for use on charter vessels, in preventing unwanted alteration of
calibration settings.

Response settings

The depth response value determines the frequency at which
information is updated. A low number provides a smooth response and
a high number a much livelier response.
Use the offset
required value. Response values are from 1 to 15.

Boat show mode

CAUTION:
Do NOT enable this mode. It must only be used for demonstration
purposes.
Ensure that the Boatshow Mode is set to OFF. If necessary, use the
offset or reset offset offset
offset offset
offset offset reset reset
offset offset or reset reset key to set the User calibration either ON reset
offset offset (decrement) and reset offset
offset
reset key to achieve this. reset reset
reset
ST60 Depth Instrument Owner's Handbook
reset (increment) keys to set the reset reset
reset