Scanning For Wireless Access Points (Aps) - Ubee DDW3611 User Manual

Ubee Interactive
Regulatory Mode
Pre-Network Radar Check
In-Network Radar Check
TPC Mitigation (dB)
OBSS Coexistence
STBC Tx
Apply
Restore Wireless Defaults
Scan Wireless APs
6.1.1

Scanning for Wireless Access Points (APs)

You can search for wireless access points and display the results in a new window.
Steps
To search for wireless access points:
1. Click Scan Wireless APs at the bottom of the Wireless Radio screen. Results are
displayed in a new window.
Ubee DDW3611 Wireless Cable Modem Gateway Subscriber User Guide • November 2012
Label
Defines whether Regulatory Mode is set to off, 802.11d, or
802.11h.
Defines the number of seconds to check for radar on a
channel before establishing a network. Current specs specify
60 seconds. Range 0-99. Zero disables checking. Designed
so APs avoid channels that contain radar systems. Used for
802.11h only.
Defines the number of seconds to check for radar when
switching to a new channel after a network has been
established. Current specs specify 60 seconds. Range: 10-99.
Cannot be disabled. Designed so APs avoid channels that
contain radar systems. Used for 802.11h only.
Sets TPC Mitigation to 0 (off), 2,3, or 4.
Enables or disables overlapping BSS coexistence.
Sets the space-time block codes (STBCs) for the transmitting
antenna.
Saves all screen changes when clicked.
Restores the factory default settings for wireless
configurations when clicked.
Scans for other wireless access points and displays channel,
encryption, SSID, RSSI levels, and other information.
Using the Wireless Radio Option
Description
59