IBM Midrange System DS4000 Series Hardware Manual page 503

Command
save storageSubsystem
supportData
set storageSubsystem
set storageSubsystem
redundancyMode
set storageSubsystem time
set storageSubsystem alarm
set enclosure id
set storageSubsystem
enclosurePositions
show storageSubsystem
autoConfiguration
show storageSubsystem
connections
show storageSubsystem
show storageSubsystem
hostTopology
show storageSubsystem
lunMappings
show storageSubsystem
unreadableSectors
start storageSubsystem
locate
stop storageSubsystem
driveFirmwareDownload
stop storageSubsystem
locate
Description
This command saves the support related information to a file.
Support related information includes:
Storage subsystem profile
Major Event Log (MEL) information
Read Link Status (RLS) data
NVSRAM data
Current problems and associated recovery information
Performance statistics for the entire storage subsystem
Persistent registration and reservation information
Detailed information about the current status of the storage
subsystem
Physical disk diagnostic data
A recovery profile for the storage subsystem
Unreadable sectors detected on the storage subsystem
State capture data
This command defines the properties of the storage subsystem.
This command sets the storage subsystem redundancy mode to
either simplex or duplex. Use simplex mode when you have a single
controller. Use duplex mode when you have two controllers.
This command sets the clocks on both controllers in a storage
subsystem by synchronizing the controller clocks with the clock of
the host from which you issue this command.
This command sets the alarm on or off.
This command sets the enclosure ID of a controller module or a
expansion drawer in a storage subsystem.
This command defines the position of all enclosures in the storage
subsystem.
This command displays the default autoconfiguration that the
storage subsystem will create if you issue the autoConfigure
storageSubsystem command.
This command lists where drive channel ports are located and
where drive channels are connected.
This command returns configuration information about the storage
subsystem.
This command returns storage partition topology, host type labels,
and host type index for the host storage subsystem.
This command returns information from the array profile about the
storage subsystem LUN mappings.
This command returns a table of the addresses of all sectors in the
storage subsystem that cannot be read.
This command locates a storage subsystem by turning on the
indicator lights for the storage subsystem.
This command stops a firmware download to the physical disks in a
storage subsystem that was started with the download
storageSubsystem driveFirmware command.
This command turns off the storage subsystem indicator lights that
were turned on by the start storageSubsystem locate command.
Chapter 8. Command-line interface and Script Editor
485