IBM Midrange System DS4000 Series Hardware Manual page 502

Command
clear storageSubsystem
eventLog
clear storageSubsystem
firmwarePendingArea
disable storageSubsystem
featurePack
download storageSubsystem
driveFirmware
download storageSubsystem
firmware
download storageSubsystem
NVSRAM
enable storageSubsystem
featureKey
reset storageSubsystem
batteryInstallDate
reset storageSubsystem
RLSBaseline
reset storageSubsystem
logicalDriveDistribution
save storageSubsystem
configuration
save storageSubsystem
allEvents
save storageSubsystem
performanceStats
save storageSubsystem
RLSCounts
save storageSubsystem
stateCapture
484
IBM Midrange System Storage Hardware Guide
Description
This command clears the storage subsystem event log by deleting
the data in the event log buffer.
There is potential storage subsystem configuration damage.
This command deletes, from the pending area buffer, a firmware
image or NVSRAM values you have previously downloaded.
There is potential storage subsystem configuration damage.
This command disables a storage subsystem premium feature.
This command downloads firmware images to all physical disks in
the storage subsystem.
This command downloads firmware and, optionally, NVSRAM
values for the storage subsystem controller.
This command downloads NVSRAM values for the storage
subsystem controller.
This command enables a feature using a feature key file.
This command resets the age of the batteries in a storage
subsystem to zero days.
This command resets the Read Link Status (RLS) baseline for all
devices.
This command reassigns (moves) all logical drives to their preferred
controller.
This command creates a script file that you can use to create the
current storage subsystem logical drive configuration.
This command saves events from the Major Event Log (MEL) to a
file. You can save either all the events or only the critical events.
This command saves the performance statistics to a file. Before you
use this command, issue the set session
performanceMonitorInterval and set session
performanceMonitorIterations commands to specify how often
statistics are collected.
This command saves the RLS counters to a file. Before using this
command, issue the reset storageSubsystem RLSBaseline
command to get current data.
This command saves the state capture to a file.