Canon PIXMA MX860 series Getting Started page 81

":,_rl·. . .
~
...__··•.....''. .' ..... "',' . ' ·..
:·.;:~i,
~N~;;l~::iji:t:~~~~, '~:<!~ :>~~ ~C~\~~~~IWftif~!::~,~~~~~&~<:;L'"' \~' ,'~::
*
:~~ili:~: ~',~:~~:~<: ~}~~k~~1<;~fd~~W:'"~, ~ ~ ,.~~:_=,:"
N;
~', ~
N : N,
i
,~q:J~·:\~j{:::;:/!~,j~~'~,~~j~I;~~~j,~ .
If you do not find a description for your trouble here, refer to "Troubleshooting" in the on-screen manual:
Basic Guide/Advanced Guide.
This manual describes troubleshooting tips for problems you may encounter when
setting up.
4.1 The machine is not detected P.2
4.2 No machine is detected after the network settings are changed in Windows
&~
P.2
• Troubles in Setup/Connections
Connection checklist
112
r::~nnot
connect to the access point (the access point is not detected)
2.1 The target access point is not detected
2.2 Cannot connect to the target access point
2.3 Using the machine in a multiple access point setup
3 How to set a network key/network password
3.1 About Network Key (Windows)/Network Password (Macintosh)
3.2 How to set a WEP/WPA/WPA2 key
114
r::~nnot
connect to the machine (the machine is not detected)
e following screen is displayed during setup
P.1
P.1
P.1
P.1
P.1
P.2
P.2
p.
P.3
5A The Another access point with the same SSID exists is displayed during setup
5.5 The New port could not be created is displayed during setup
5.6 The Set Printer IP Address screen is displayed during setup
5.7 The Enter Password screen is displayed during setup
5.8 The You have connected the printer to an unsecured wireless network is
displayed during setup
5.9 The Communication with the Card Slot failed is displayed during setup
5.10 The The Card Slot is already mapped as Network Drive to this computer is
displayed during setup
5.11 The Cannot map any more drives, because all the drive letters are assigned is
displayed during setup
5.12 The Timeout error screen is displayed during WPS setup
«
'6 R,e-sietltin!:J tl,e machine
e admin password set to the machine was forgotten
Changing the port name ~
. • Restoring the Machine to the Factory Settings
1 Initializing using the machine's Operation Panel
. • Specifications
PA
PA
PA
P.5
P5
P.5
P.6
P.6
P.6
P.
P.6
P.6
P.7
5.1 The Access Points screen is displayed during setup P.3
5.2 The An access point could not be detected is displayed during setup P.3
5.3 The Printer could not be connected to the specified access point is displayed
during setup PA