Table of Contents
Advertisement
SEBU8728
4. Clean the cooling system filler cap and inspect the
gasket. If the gasket is damaged, discard the old
filler cap and install a new filler cap. If the gasket is
not damaged, use a suitable pressurizing pump in
order to pressure test the filler cap. The correct
pressure is stamped on the face of the filler cap. If
the filler cap does not retain the correct pressure,
install a new filler cap.
Driven Equipment - Check
Refer to the OEM specifications for more information
on the following maintenance recommendations for
the driven equipment:
• Inspection
• Adjustment
• Lubrication
• Other maintenance recommendations
Perform any maintenance for the driven equipment
which is recommended by the OEM.
Engine - Clean
Personal injury or death can result from high
voltage.
Moisture
can
create
conductivity.
Make sure that the electrical system is OFF. Lock
out the starting controls and tag the controls " " DO
NOT OPERATE" " .
NOTICE
Accumulated grease and oil on an engine is a fire
hazard. Keep the engine clean. Remove debris and
fluid spills whenever a significant quantity accumu-
lates on the engine.
NOTICE
Failure to protect some engine components from
washing may make your engine warranty invalid. Al-
low the engine to cool for one hour before washing
the engine.
i00174798
i02683047
paths
of
electrical
Maintenance Recommendations
Periodic cleaning of the engine is recommended.
Steam cleaning the engine will remove accumulated
oil and grease. A clean engine provides the following
benefits:
• Easy detection of fluid leaks
• Maximum heat transfer characteristics
• Ease of maintenance
Note: Caution must be used in order to prevent
electrical components from being damaged by
excessive water when the engine is cleaned. When a
pressure washer or steam cleaner is used to clean
the engine, a minimum distance of 300 mm (12 inch)
must be maintained between the components of the
engine and the jet nozzle of the pressure washer or
steam cleaner. Pressure washers and steam cleaners
should not be directed at any electrical connectors or
the junction of cables into the rear of the connectors.
Avoid electrical components such as the alternator
and the starter. Protect the fuel injection pump from
fluids in order to wash the engine.
Engine Air Cleaner Element
(Dual Element) - Inspect/Clean/
Replace
NOTICE
Never run the engine without an air cleaner element
installed. Never run the engine with a damaged air
cleaner element. Do not use air cleaner elements with
damaged pleats, gaskets or seals. Dirt entering the
engine causes premature wear and damage to en-
gine components. Air cleaner elements help to pre-
vent airborne debris from entering the air inlet.
NOTICE
Never service the air cleaner element with the engine
running since this will allow dirt to enter the engine.
Servicing the Air Cleaner Elements
Note: The air filter system may not have been
provided by Perkins . The procedure that follows is
for a typical air filter system. Refer to the OEM
information for the correct procedure.
If the air cleaner element becomes plugged, the air
can split the material of the air cleaner element.
Unfiltered air will drastically accelerate internal engine
wear. Refer to the OEM information for the correct air
cleaner elements for your application.
67
Driven Equipment - Check
i04150582
Hide quick links:
Advertisement
Chapters
Table of Contents
