TENSIONING THE BELT
If you can feel a slipping sensation when running on the treadmill, the running belt must
be tightened. In most cases, the belt has stretched from use, causing the belt to slip. This
is a normal and common adjust-
ment. To eliminate this slipping,
tension both the rear roller bolts
with the appropriate size allen
wrench, turning it 1/4 TURN to
the right as shown. Try the tread-
mill again to check for slipping.
Repeat if necessary, but NEVER
TURN the roller bolts more than
1/4 turn at a time. the belt ten-
sion is set properly when the run-
ning belt is 1/4 of an inch from
the deck.
CENTERING THE BELT
If the running belt is too far to the right side, use the supplied Allen wrench to turn the
right tension bolt clockwise 1/4 turn at a time until the belt remains centered during use.
If the running belt is too far to the left side, turn the left tension bolt clockwise 1/4 turn at
a time until the belt remains centered during use.
IF THE BELT IS TOO FAR TO
THE LEFT SIDE:
• Turn the left roller bolt 1/4 turn
clockwise (tighten).
IF THE BELT IS TOO FAR TO
THE RIGHT SIDE:
• Turn the right roller bolt 1/4
turn clockwise (tighten).
31
TREADMILL SERIES
PAUSE
Press the Stop button to pause your workout.
RESET
Press and hold the Stop button to reset the treadmill.
Metric
British
OMEGA II
10