NordicTrack Elite 4000 User Manual page 5

35. Secure an antenna lead-in and ground wires
to the house with standoff insulators spaced
from 4 to 6 feet (1.22 to 1.83 m) apart.
36. Mount an antenna discharge unit as close
as possible to where the lead-in enters the
house.
37. Use a jumper wire not smaller than No. 6
AWG (13.3 mm ) copper, or the equivalent,
2
when a separate antenna-earthing elec-
trode is used. See your local codes and
ordinances.
Power Lines
Service
Entrance
Conductors
Power Service Earthing
Electrode System (e.g.
Interior Metal Water Pipe)
To External 75 Ohm
Terminal of Treadmill
Service
Entrance
Equipment
Ground
Clamps
SAVE THESE INSTRUCTIONS
38. Note to CATV system installer: This reminder
is provided to call the CATV system install-
er's attention to your local codes guidelines
for proper earthing and, in particular, speci-
fies that the cable ground shall be connected
to the earthing system of the building, as
close to the point of cable entry as practical.
Ground
Clamp
Ground
Wire
Ground Wire
Ground
Bonding
Clamps
Jumper
Optional Antenna Earthing Electrode Driven
8 Feet (2.44 m) Into The Earth (If Required
By Local Codes).
5
Standoff
Insulators
Mast
Antenna
Lead-in Wire
Antenna
Discharge Unit