NordicTrack Elite 4000 User Manual page 10

6. Hold the Tray (79) near the right Upright (84).
Wrap the tie in the hole in the side of the Upright
around the end of the fan wire (B). Pull the
fan wire into the hole and out of the top of the
Upright. Then, remove the tie.
Identify the #8 x 3/4" Screws (5). IMPORTANT:
Do not confuse the #8 x 3/4" Screws with the
#8 x 3/4" Truss Head Screws (24). The #8 x
3/4" Truss Head Screws have flatter heads.
Attach the Tray (79) to the Upright Crossbar (76)
with four #8 x 3/4" Screws (5). Start all four
Screws, and then tighten them.
7. Attach the two Handrails (74) to the Uprights (84)
with two of the 5/16" x 2" Screws (2) that you
removed in step 3 and two 5/16" Star Washers
(8). Do not fully tighten the Screws yet. Be
careful not to pinch the Upright Coaxial Cable
(78), the Upright Wire (83), or the fan wire (B).
Position the wires as shown.
Then, remove and discard the two indicated
screws (C).
6
B
Hole
Tie
5
84
7
2
8
74
C
10
79
76
5
78
74
2
B
8
83
84
84
C