Unpacking Instructions - Emerson Designer Remote CF759AB03 Owner's Manual

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Tools Needed for Assembly
One Phillips head screwdriver
One 1/4" blade screwdriver
Three wire connectors (supplied).
MATERIALS
1. Wiring outlet box and box connectors must be of
type required by the local code. The minimum wire
would be a 3-conductor (2-wire with ground) of the
following size:
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a
check mark in the box. This will insure that all steps have been completed and will be helpful in finding
your place should you be interrupted.
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or acces-
sories not designated for use with this product by
Emerson Electric Co. could result in personal injury
or property damage.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One switch housing assembly
c. Five fan blades
d. One ceiling cover
e. Five blade flanges
f. One remote control (transmitter and receiver)
g. Four 25-watt candelabra bulbs
h. One hanger ball/downrod assembly
i. One hanger bracket
j. One coupling cover
k. One loose parts bag containing:
1. Sixteen M5 x 6 washer head blade
screws
2. Sixteen blade washers
3. One M6 x 14 captive screw with
lockwasher
4. Three wire connectors
5. Two threaded studs
6. Two knurled knobs
7. Two lockwashers
8. One clevis pin
9. One hairpin clip
Install, Operate and Maintain Your Ceiling Fan
One stepladder
One wire stripper

Unpacking Instructions

Installed Wire Length
Up to 50 ft.
50-100 ft.
2. A 9-volt alkaline battery is required for operating
the remote control.
!
Before assembly your ceiling fan, refer to section on
proper method of wiring your fan (page 7). If you feel
you do not have enough wiring knowledge or experi-
ence, have your fan installed by a licensed electrician.
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local retail-
er or catalog outlet for replacement before
proceeding.
2. Remove the fan motor assembly from the
protective plastic bag and place it into the lower
foam pad with the top of the fan motor assembly
facing up.
The lower foam pad serves as a holder for the fan
during assembly.
REMOTE CONTROL
RECEIVER
LOOSE
PARTS
BAG
BLADE
FLANGES
CEILING
COVER
3
Wire Size A.W.G.
14
12
WARNING
REMOTE CONTROL
TRANSMITTER
FAN MOTOR
ASSEMBLY
SWITCH
HOUSING
ASSEMBLY
COUPLING
COVER
25-WATT
CANDELABRA
BASE BULBS
HANGER BALL/
DOWNROD
ASSEMBLY
HANGER
BRACKET
FAN
BLADES