Table of Contents
Advertisement
5
Printing Operation
5.1
Printhead Protection
Attention!
!
Printhead damage caused by improper handling!
Do not touch the heating elements of the printhead with the fingers or sharp objects.
Ensure that the material is clean.
Ensure that the material surfaces are smooth. Rough material act like emery paper and reduce the
service life of the printhead.
Print with the lowest possible printhead temperature.
The printer is ready for operation when all connections have been made and labels and, if applicable, the transfer
ribbon have been loaded.
5.2
Synchronization in Cut Mode
To guarantee the correct length of the first label a cut prior print job is required :
Activate in the printer driver menu General > Print Settings > Advanced Setup the setting "cut before labels".
or
For direct programming use the command C s Programming Manual.
5.3
Suppressing Backfeed (A4+T only)
Notice!
i
Feeding back the material to the printhead in the cut mode or between print jobs is not allowed for A4+T.
To avoid the backfeed :
In the printer driver menu General > Print Settings > Advanced Setup > Options
•
activate the setting "Ignore label position" and
•
deactivate the setting "Single buffer mode".
or
For direct programming Programming Manual
•
use the command O F and
•
do not use the command O S.
17
Hide quick links:
Advertisement
Table of Contents
