JVC RX-E100RSL Service Manual page 5

Removing the audio board
Prior to performing the following procedure, remove
the top cover , the rear panel and the each board.
1. Disconnect the card wire from connector CN411 on
the audio board.
2. Disconnect the harness from connector CN205 on the
audio board.
3. Disconnect the harness from connector CN515,
CN516, and CN517on the main board.
4. Remove the harness band fixing the harness.
5. Remove the three screws G
board assembly.
Removing the main board
Prior to performing the following procedure, remove
the top cover, the rear panel and audio board.
1. Remove the harness band fixing the harness.
2. Disconnect the harness from connector CN707 on
the power supply board .
3. Disconnect the harness from connector CN202 and
CN206 on the main board .
4. Remove the five screws H and the two screws I
attaching the main board.
Removing the Heat sink
1. Remove the ten screws K and four screws L
attaching the heat sink.
2. Remove the two screws J attaching the heat sink
from the rear side of main board.
(See Fig.8)
attaching the audio
(See Fig.9)
(See Fig.10 to 11)
Main board
CN515
CN411
G
Audio Harness
board band
Fig.8
H
H
I
H
Main
board
H
Fig.9
J
Main board
Fig.10
rear side
Heat sink
K
L
Fig.11
RX-E100RSL/RX-E100RSB
CN517
CN516
power
supply
board
Power
transformer
Power / Fuse
CN205
board
I
CN707
CN206
CN202
Harness
band
J
K
K
L
1-5