Download Print this page

JVC RX-E100RSL Service Manual page 3

Audio/video control receiver
Hide thumbs Also See for RX-E100RSL:

Advertisement

Disassembly method
Removing the top cover (See Fig.1)
1.
Remove the four screws A attaching the top cover
on both sides of the body.
2.
Remove the three screws B on the back of the body.
3.
Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
Removing the front panel assembly
Prior to performing the following procedure, remove
the top cover.
1.
Disconnect the card wire from connector CN411 on
the audio board, CN412 on the input board and
CN204 on the power supply board in the front panel
assembly.
2.
Cut off the tie band fixing the harness.
3.
Remove the three screws C
panel assembly.
4.
Remove the four screws D attaching the front panel
assembly on the bottom of the body. Detach the front
panel assembly toward the front.
Removing the rear panel (See Fig.4)
Prior to performing the following procedure, remove
the top cover.
1.
Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
2.
Remove the twenty one screws E
each boards to the rear panel on the back of the
body.
3.
Remove the four screws F attaching the rear panel
on the back of the body.
(See Fig.2 and 3)
attaching the front
attaching the
Top cover
A
2
A
2
C
Tie band
Main
board
CN411
Audio
board
CN412
Input
Fig.2
board
D
Fig.3
Rear panel
E
E
F
E
E
Fig.4
RX-E100RSL/RX-E100RSB
B
Fig.1
Front panel assembly
C
CN204
Power supply
board
Front panel assembly
D
E
E
Cord stopper
F
F
E
F
1-3

Advertisement

loading

This manual is also suitable for:

Rx-e100rsb