Chapter 2. Preparations And Setting Up; Connect The Power; Connect To A Display; Installation Of Dsa Composer And Dsa Configurator - Advantech DSA-2101 Series User Manual

Network digital signage player

Table of Contents

Chapter 2. Preparations and Setting Up

1. Connect the power adapter cord with the AC power cord.

2. Connect the power adapter cable to the player's DC 12V power port. See Figure 2-1.

3. Plug the AC power cord into a power outlet and the Power LED (green) will light up.

Warning:

Only use the power adapter packaged with the DSA-2101/2102. Using a different

power adapter could damage the device.

Connect your display to the Digital Signage Player's DVI port with the DVI cable that came

with your display. Consult your display's user manual for cabling specifications.

Note:

2. The DSA-2101/2102 is equipped with DVI-I port which can output the display with

VGA (D-sub 15-pin) connector through a DVI-I-to-VGA adaptor.

3. If you would like to use the Composite or S-Video video output, you need to

change the player's configuration setting with the DSA Configurator. See Section

4.4.3.

You can install the DSA Composer on any Microsoft Windows based server or PC as a

management station to provide simple content-display management of the DSA player

(Advantech Digital Signage player). DSA Composer is created primarily for evaluation of

the RISC-based Advantech Digital Signage Player.

development of the signage software.

Note:

You can download the latest version of DSA Composer / DSA Configurator from the

following URL:

http://www.advantech.com.tw/support/

Follow the steps below for installation of DSA Composer and DSA Configurator:

Figure 2-1

SDK is available for further

Table of Contents

Dsa-2102 series