Log, Lava Rock And Ember Placement - Vermont Castings Chateau DVT38 Installation Instructions And Homeowner's Manual

Chateau™
3. Start with either the right side refractory or left side
refractory. Hold the refractory at an angle. Slide
and seat the bottom edge toward the bottom of the
firebox. Tilt it carefully toward the side until the piece
is in place. Slide the refractory forward until it comes
in contact with the front flange on the firebox.
4. Holding the rear refractory lower straight up, rotate
it back behind the side refractory and set it on the
small return bend of the rear log bracket toward the
back of the firebox. Ensure the mortar lines in the
refractory match the side refractory already installed.
5. Rotate back and set on the rear log bracket toward
the back of the firebox.
Unpack the logs and log burner overlay from packag-
ing. Remove each log from its wrapping material.
Tools required: Robertson or Phillips screwdriver
The logs are fragile and should be handled
with care. Keep the packaging materials
out of the reach of children and dispose of
the material in a safe manner.
DVT38 Logs
Log Grate Burner
Log Burner Overlay
Log Grate Right
Log Grate Left
Fig. 40 DVT38 log identification.
22

Log, Lava Rock and Ember Placement

Log Rear Right
Log Rear Left
Log Front Left
LG412
DVT38 log ID
6. The rear refractory upper has a notch in the top side.
Holding the refractory at an angle, slide the refrac-
tory behind the side refractory installed.
7. While holding the rear refractory upper in place, fol-
low Step 3 and install the remaining side refractory.
8. Adjust all refractory pieces so mortar lines are
aligned. Replace heat shield removed in Step 2.
Make sure the angle on the heat shield goes back.
This will secure the side refractory in place.
9. Slide the right and left lower refractories into place in
front of the burner and align.
10. Reinstall the burner tube and fettle.
IMPORTANT: Review these instructions and famil-
iarize yourself with each log before beginning log
placement. Find the notches, pins and indentations
on each log. Follow the instructions closely, using
the Log ID (Fig. 40 or 41) and the illustrations to as-
sist in correctly placing each log.
Log Front Middle Left
Log Front Middle Right
Log Front Right
Log Front Upper Right
LG412
20009145