Polaris BRUTUS Owner's Manual page 36

MAINTENANCE
Cleaning The Snow Blower
WARNING!
.
AVOID INJURY OR DEATH
Wear safety glasses to prevent eye injury when any of the following conditions exist:
.
• When fluids are under pressure
.
• Flying debris or loose material is present
• Engine is running.
• Tools are being used.
Stop the machine and attachment on a flat level surface. Put the gear selector lever in PARK. Disengage the PTO and place all
controls in neutral. Stop the engine, unfasten the seat belt, remove the key and exit the machine.
Disconnect the PTO driveline. See page 19.
Use water or air pressure to clean debris from the snow blower.
Adjusting Chute Rotation Gears
Remove the two bolts and nuts (Item 1) and cover (Item 2).
Installation: Install the two bolt standoffs (Item 3) and cover
(Item 2). Tighten the two bolts and nuts (Item 1).
Loosen the four bolts (Item 4). Slide the motor (Item 5) until the
motor gear (Item 6) meshes with the chute gear (Item 7).
1
Tip: Leave a small gap between the teeth. Do not bottom the teeth out
on each other. Premature tooth wear can result.
Tighten the four bolts (Item 4).
2
Install the cover.
3
WARNING!
AVOID INJURY OR DEATH
Never operate with covers or guards removed.
7
6
4
5
35