Connecting The Speakers - JVC RX-8020VBK Instructions Manual

AM Antenna Connections
ANTENNA
Turn the loop until you have
FM 75
the best reception.
COAXIAL
AM Loop Antenna
AM
LOOP
(supplied)
AM
EXT
2
1
Outdoor single vinyl-covered wire (not supplied)
Notes:
• If the AM loop antenna wire is covered with vinyl (not
supplied), remove the vinyl by twisting it as shown in the
diagram.
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. This could cause poor
reception.
• If reception is poor, connect an outdoor single vinyl-covered wire
(not supplied) to the AM EXT terminal. (Keep the AM loop antenna
connected.)
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop.
3

Connecting the Speakers

You can connect the following speakers:
• Two pairs of front speakers to produce normal stereo sound.
• One pair of surround speakers to enjoy the surround effect.
• One surround back speaker or one pair of surround back speakers
to enjoy 6.1-channel sound reproduction.
• One center speaker to produce more effective surround effect (to
emphasize human voices).
• One subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker
setting information properly to obtain the best possible
Surround and DSP effect. For details, see page 22.
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Typical speaker layout
Center speaker
Left front speaker(s)
Left surround speaker Left surround speaker
Surround back speaker(s)
Subwoofer
Right front speaker(s)
Right surround speaker
6