Connecting The Speakers - JVC RX-D302BC Instructions Manual

Connecting the speakers

Do not connect the AC power plug to the wall outlet until all connections are completed.
Speaker Layout Diagram
C
L
LS
SBR
SBL
(*SB)
CAUTIONS:
• Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals (6 Ω – 16 Ω).
• DO NOT connect more than one speaker to one speaker
terminal.
Connecting the speakers
Turn off all components before making connections.
Connecting the center speaker and the front speakers
1 2
1
Twist and remove the insulation at the end of each
speaker cord.
2
Turn the knob counterclockwise.
3
Insert the speaker cord.
• For each speaker, connect the (+) and (–) terminals on the
rear panel to the (+) and (–) terminals marked on the
speakers.
4
Turn the knob clockwise.
6
SW
R
Right surround
back speaker
(SBR)
RS
*Left surround
back speaker
(SBL)
Right surround
speaker (RS)
3 4
Center
speaker (C)
CAUTION:SPEAKER
IMPEDANCE 6 -16
RIGHT LEFT RIGHT LEFT
SURROUND BACK SURROUND CENTER
SPEAKERS SPEAKERS SPEAKER
Left surround
speaker (LS)
Connecting the surround speakers and the surround back
speakers
1 2
1
Twist and remove the insulation at the end of each
speaker cord.
2
Open the terminal (1), then insert the speaker cord
(2).
• For each speaker, connect the (+) and (–) terminals on the
rear panel to the (+) and (–) terminals marked on the
speakers.
3
Close the terminal.
*When using a single speaker for the surround back speaker
You can enjoy the surround sound by one surround back
speaker. When using one surround back speaker,
< >
– set "SB OUT" to " 1SPK
– connect the surround back speaker to the left surround back
speaker terminal. (No sound comes from the speaker if
you connect it to the right surround back speaker
terminal.)
Connecting the powered subwoofer
By connecting a subwoofer, you can enhance the bass or
reproduce the original LFE signals recorded in digital software.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cord
with RCA pin plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
After connecting all the speakers and/or a subwoofer, set the
speaker setting information properly to obtain the best possible
surround effect. For details, see pages 17 to 21.
NOTE
You can place a subwoofer wherever you like since bass sound is
non-directional. Normally place it in front of you.
SUBWOOFER
OUT
RIGHT LEFT
Powered
FRONT
SPEAKERS
subwoofer
(SW)
Right front Left front
speaker speaker
(R) (L)
3
1
2
" (see page 19) and