Receiving Radio Broadcasts; Tuning Into Stations Manually; Using Preset Tuning - JVC RX-8020VBK Instructions Manual

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

Tuning into Stations Manually

On the front panel:
1. Press FM/AM to select the band
(FM or AM).
The FM/AM lamp on the front panel button
lights up. The last received station of the
selected band is tuned in.
• Each time you press the button, the band
alternates between FM and AM.
ANALOG L R
SPEAKERS 1
2. Press FM/AM TUNING 5 or ∞
until you find the frequency you
want.
• Pressing FM/AM TUNING 5 increases
the frequency.
• Pressing FM/AM TUNING ∞ decreases
the frequency.
From the remote control:
1. Press FM/AM to select the band
(FM or AM).
The FM/AM lamp on the front panel button
lights up. The last received station of the
selected band is tuned in.
• Each time you press the button, the band
alternates between FM and AM.
2. Press TUNING UP 3 or
TUNING DOWN 2 until
you find the frequency you
want.
• Pressing TUNING UP 3 increases the
frequency.
• Pressing TUNING DOWN 2 decreases the
frequency.
Notes:
• When a station of sufficient signal strength is tuned in, the TUNED
indicator lights up on the display.
• When an FM stereo program is received, the STEREO indicator
also lights up.
• When you hold and then release the button in step 2, the frequency
keeps changing until a station is tuned in.
27
Once a station is assigned to a channel number, the station can be
quickly tuned in. You can preset up to 30 FM and 15 AM stations.
FM/AM
To store the preset stations
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 2 again.
On the front panel ONLY:
TUNED STEREO
1. Tune in the station you want to preset (see
VOLUME
FM/AM TUNING
2. Press MEMORY.
FM / AM
3. Press FM/AM PRESET 5 or ∞ to
/REW FF/
PAUSE
SET
DOWN – TUNING – UP
4. Press MEMORY again while the
5. Repeat steps 1 to 4 until you store all the stations
To erase a stored preset station
Storing a new station on a used number erases the previously stored
one.

Using Preset Tuning

"Tuning into Stations Manually" on the left).
• If you want to store the FM reception mode for this station,
select the FM reception mode you want. See "Selecting the
FM Reception Mode" on page 28.
ANALOG L R
SPEAKERS 1
L R
ANALOG
SPEAKERS 1
The channel number position starts flashing on the display for
about 10 seconds.
select a channel number while the
channel number position is
flashing.
ANALOG L R
SPEAKERS 1
selected channel number is
flashing on the display.
The selected channel number stops flashing.
The station is assigned to the selected channel number.
L R
ANALOG
SPEAKERS 1
you want.
TUNED STEREO
VOLUME
MEMORY
TUNED STEREO
VOLUME
FM/AM PRESET
TUNED STEREO
VOLUME
MEMORY
TUNED STEREO
VOLUME