Adjusting The Sound Parameters For The Surround And Dsp Modes-Effect Adjust - JVC RX-8020VBK Instructions Manual

Adjusting the Sound Parameters for the
Surround and DSP Modes—EFFECT ADJUST
You can adjust the Surround and DSP sound parameters to your
preference.
• Once you have made adjustment, it is memorized for each source.
7 Adjustable parameters
You can adjust the following parameters:
For Surround, DAP, JVC Theater Surround and All Channel
Stereo modes (when the center speaker is connected)
CENTER TONE : Adjust the center tone. As the number
(CTR TONE) increases, the dialogue becomes clearer so
that the human voices change from soft to
sharp. (Normally select "3." Adjustable range:
1 to 5)
For DAP modes and JVC Theater Surround
EFFECT LEVEL :
Adjust the DAP effect level. As the
(EFFECT)
number increases, the DAP effect
becomes stronger. (Normally select "3."
Adjustable range: 1 to 5)
Adjust the virtual room size. As the
ROOM SIZE :
number increases, the interval between
(ROOMSIZE)
reflections increases so that you will feel
as if you were in a larger room. (Normally
select "3." Adjustable range: 1 to 5)
Adjust the liveness effect. As the number
LIVENESS :
increases, the attenuation level of
reflections over time decreases so that
acoustics change from "Dead" to "Live."
(Normally select "3." Adjustable range: 1 to 5)
Note:
You can only adjust the Effect Level when using a DAP mode with
the 3D-PHONIC indicator lights up.
For Pro Logic II Music only
Select "ON" to add "wraparound" sound
PANORAMA :
effect with side-wall image. (Initial
(PNRAMA)
setting: "OFF")
control
CENTER WIDTH : Adjust the center channel localization
between the center speaker and the left/
(CWIDTH)
right speakers. As the number increases, the
center channel sound moves toward the left
and right speakers. (Normally select "3."
Adjustable range: OFF and 1 to 7)
Adjust sound localization position. As the
DIMENSION :
number increases, the sound localization
moves towards forward from backward.
(Normally select "4." Adjustable range: 1 to 7)
Note:
Parameters that are not adjustable for the currently selected Surround
and DSP modes are skipped.
Using the on-screen display (through the remote control]:
1. Show EFFECT ADJUST menu (see page 38).
Parameters that are not adjustable for the currently
selected Surround and DSP modes are skipped.
2. Press 5 or ∞ to move
want to adjust.
3. Press 2 or 3 to adjust the parameter.
4. Repeat steps 2 and 3 to adjust the other
parameters.
5. When you finish, press EXIT repeatedly until the
menu disappears from the TV.
On the front panel:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1. Press EFFECT repeatedly to select a
parameter you want to adjust.
• Each time you press the button, the items change
as follows:
EFFECT = ROOMSIZE = LIVENESS =
CTR (center) TONE = PNRAMA (Panorama) =
C (center) WIDTH = DIMENSION =
(Back to the beginning)
Parameters that are not adjustable for the currently selected
Surround and DSP modes are skipped.
2. Press CONTROL UP 5 or
DOWN ∞ to adjust the sound
parameter.
3. Repeat steps 1 and 2 to adjust the other
parameters.
to a parameter you
EFFECT SETT
CONTROL
DOWN UP
42