JVC RX-8020VBK Instructions Manual page 127

PROBLEM
"OVERLOAD" starts flashing on the
display.
The STANDBY lamp lights up after
turning on the power, and soon the
receiver turns off again (into standby
mode).
Remote control does not work.
Remote control does not work intendedly.
POSSIBLE CAUSE
Speakers are overloaded because of
high volume.
Speakers are overloaded because of
short circuit of speaker terminals.
The receiver is overloaded because of
high voltage.
There is an obstruction between the
remote sensor on the receiver and the
remote control.
Batteries are weak.
An incorrect remote control operation
mode is selected.
SOLUTION
1.Press STANDBY/ON on the front panel to
turn off the receiver.
2.Stop the playback source.
3.Turn on the receiver again and adjust the volume.
Press STANDBY/ON on the front panel to turn
off the receiver, then check the speaker wiring.
If "OVERLOAD" does not disappear, unplug the AC
power cord, then plug it back again.
If speaker wiring is not short-circuited, contact your
dealer.
Press STANDBY/ON on the front panel to turn
off the receiver. After unplugging the AC power
cord, consult your dealer.
Remove the obstruction.
Replace batteries. (See page 15.)
Select the correct remote control operation mode.
(See pages 51 to 53.)
58