LG 50PQ30 Training Manual page 25

Left and Right X Drive Removal
Left and Right X Drive Removal
After removing the back cover, the Main board is lifted out of the way, the 9 screws removed from heat sink
covering the TCPs and connectors to the TCPs are removed, the X-Drive boards can be removed.
There may be tape on the connectors P231 or P232
Disconnect connector P122
P231 P232
P122
Peel the tape off the connectors
Va from the Y-SUS
Remove tape (if present) and Gently pry the
locking mechanism upward and remove the ribbon
cable from the connector.
Carefully lift the TCP ribbon up and off.
It may stick, be careful not to crack TCP.
(See next page for precautions)
Removing Connectors to the TCPs.
Gently lift the locking mechanism
upward on all TCP connectors
Left X: P101~105
Center X: P201~206
Cushion (Chocolate)
Right X: P301~305
TCP
Flexible ribbon cable connector
25 November 2009 50PQ30 Plasma