Table of Contents
Advertisement
Basic Operations
The following operations are commonly used when you play any sound source.
Turning the Power On and Off (Standby)
On the front panel:
To turn on the power, press POWER.
The STANDBY lamp goes off. The name of the
current source (or station frequency) appears on
the display.
Current source name appears
Current volume level is shown here
To turn off the power (into standby mode),
press POWER again.
The STANDBY lamp lights up. A small amount
of power is consumed in standby mode. To turn
the power off completely, unplug the AC power
cord.
From the remote control:
To turn on the power, press AUDIO POWER.
The STANDBY lamp goes off. The name of the
current source (or station frequency) appears on
the display.
To turn off the power (into standby mode),
press AUDIO POWER again.
The STANDBY lamp lights up.
Selecting the Source to Play
Press one of the source selecting buttons.
On the front panel:
DVD
TV SOUND/DBS
SOURCE NAME
CD
TAPE/MD
SOURCE NAME
From the remote control:
DVD
TV SOUND/ DBS
VCR
CD
TAPE/MD
8
STANDBY
POWER
STANDBY
POWER
AUDIO
VCR
PHONO
FM/AM
PHONO
FM/AM
Selected source name appears
DVD
Select the DVD player for viewing the stereo
digital video disc.
TV SOUND/DBS Select the TV sound (or the DBS tuner).
VCR
Select the video component connected to the
VCR jacks.
CD *
Select the CD player.
TAPE/MD *
Select the cassette deck (or the MD recorder).
PHONO *
Select the turntable.
FM/AM *
Select an FM or AM broadcast.
• Each time you press the button, the band
alternates between FM and AM.
Notes:
• When connecting an MD recorder (to the TAPE/MD jacks) or a DBS
tuner (to the TV SOUND/DBS jacks), change the source name that
appears on the display. See page 11 for details.
• When you press one of the source selecting buttons on the remote
control marked above with an asterisk ( * ), the receiver
automatically turns on.
Signal and speaker indicators on the display
• The signal indicators light up to indicate the incoming channel
signals.
– Only the indicators for the incoming signals light up. (When
analog input is selected, "L" and "R" always light up.)
• The frame of the signal indicator (except for "LFE": See notes
below) lights up if the corresponding speaker is set to "LARGE"
or "SMALL" (for subwoofer, "YES").
L
SUBWFR
LS
L:
Light up when the left front channel signal comes in.
The frame of this signal indicator always lights up.
R:
Light up when the right front channel signal comes in.
The frame of this signal indicator always lights up.
C:
Light up when the center channel signal comes in.
LS: Light up when the left rear channel signal comes in.
RS: Light up when the right rear channel signal comes in.
S:
Light up when the monaural rear channel signal comes in.
LFE: Light up when the LFE channel signal comes in.
Notes:
• When the LFE channel signal comes in, "LFE" lights up.
• When "SUBWOOFER" is set to "YES," (See page 15)
lights up.
C
R
LFE
S
RS
SUBWFR
Hide quick links:
Advertisement
Table of Contents
