Adjusting The Subwoofer Output Level; Attenuating The Input Signal; Reinforcing The Bass; Adjusting The Tone - JVC RX-6100VBK Instructions Manual

Adjusting the Subwoofer Output Level

You can adjust the subwoofer output level if you have selected
"YES" for the "SUBWOOFER" (see page 15).
Once it has been adjusted, the receiver memorizes the adjustment.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel:
1. Press ADJUST repeatedly until
"SUBWFR LEVEL" appears on
the display.
• Once you have pressed ADJUST, MULTI CURSOR % / fi
can be also used for selecting "SUBWFR LEVEL."
• The display changes to show the current setting.
2. Press MULTI CURSOR @ / # to
adjust the subwoofer output level
(–10 dB to +10 dB).
From the remote control:
1. Press SOUND.
The 10 keys are activated for sound adjustments.
2. Press SUBWOOFER –/+ to adjust
the subwoofer output level (–10 dB
to +10 dB).

Attenuating the Input Signal

When the input level of the playing source is too high, the sounds
will be distorted. If this happens, you need to attenuate the input
signal level to prevent the sound distortion.
On the front panel ONLY:
Press and hold INPUT ATT. (ONE TOUCH
OPERATION) so that the ATT indicator
lights up on the display.
• Each time you press and hold the button, the
Input Attenuator mode turns on ("INPUT ATT
ON") or off ("INPUT NORMAL").
Notes:
• This function is available only for the sources connected using the
analog terminals.
• This function does not take effect when digital input is selected.
10

Reinforcing the Bass

With this Bass Boost function, you can boost the bass level.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press ADJUST repeatedly until
"BASSBOOST" (with the current
ADJUST
setting) appears on the display.
• Once you have pressed ADJUST, MULTI CURSOR % / fi
also can be used for selecting "BASSBOOST."
2. Press MULTI CURSOR @ / # to
switch this function "ON" or
"OFF."
MULTI CURSOR
• When this function is switched "ON," the
BASS BOOST indicator on the display
lights up.
Note:
SOUND
The Bass Boost function affects the front speaker sounds only.
SUBWOOFER

Adjusting the Tone

2
1
You can adjust the treble and bass sounds as you like.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press ADJUST repeatedly until
"BASS" or "TREBLE" appears on
the display.
ONE TOUCH OPERATION/
INPUT ATT. • Once you have pressed ADJUST, MULTI CURSOR % / fi
can be also used for selecting "BASS" or "TREBLE."
• Select "BASS" to adjust the bass sound level.
• Select "TREBLE" to adjust the treble sound level.
2. Press MULTI CURSOR @ / # to
adjust the bass or treble sound
level within the range of –10 to
+10.
• Each time you press the button, the sound
level changes by ± 2 steps.
ADJUST
MULTI CURSOR
ADJUST
MULTI CURSOR