Ricoh B079 Service Manual page 812

BIT SWITCHES
G4 Internal Switch 13: D channel layer 3 (Attachment IE in S: SETUP)
No.
0 Not used
1 Information transfer capability shift
down to retry transmission
0: Shift down procedure disabled
(Default)
1: Shift down and retry the call
2 Attachment of calling ID and
subaddress
0: No 1: Yes
3 Attachment of the Lower Layer
Capabilities
0: No 1: Yes
4 Attachment of the Higher Layer
Capabilities
0: Yes 1: No
5 Attachment of the channel
information element (CONN)
0: No 1: Yes
6
Attachment of the Higher Layer
Capabilities for ISDN G3
transmission
0: Same as the bit 4 setting
1: Not attached
B547
CÓPIA NÃO CONTROLADA
FUNCTION
CÓPIA NÃO CONTROLADA
COMMENTS
Do not change the setting.
1: The machine changes the ISDN G3
information transfer capability informed in
the [SETUP] signal to "Speech" from "3.1
kHz audio" or to "3.1 kHz audio" from
"Speech" automatically and retries the
transmission.
The information transfer capability used in the
first try is determined by the setting of G4
internal bit switch 14 bit 0.
This switch is effective with some types of
exchangers and T/As where they only accept
calls with information transfer capability
"Speech".
Normally, this bit should be at 0, because
most networks add the calling ID and
subaddress to the SETUP signal to the
receiver.
However, some networks may require the
machine to add this ID (and/or subaddress).
Only in this case should this bit be at 1.
This bit determines whether Lower Layer
Capabilities are informed in the [SETUP]
signal.
Keep this bit at 0 in most cases.
This bit determines whether Higher Layer
Capabilities are informed in the [SETUP]
signal or not.
Keep this bit at 0 in most cases.
Keep this bit at 0 in most cases.
This bit determines whether Higher Layer
Capabilities are informed in the [SETUP]
signal for ISDN G3 transmission. This switch
is effective in coping with communication
problems with some types of T/A and PBX
that do not respond to Higher Layer Capability
"G3".
When this bit is set to 0, the setting depends
on the setting of bit 4.
Keep this bit at 1 in most cases.
86 SM