Scenes; S1: Zero Out (Board Reset); Creating A Scene; Fat Channel Parameters - PRESONUS StudioLive 16.0.2 USB Owner's Manual

6 Digital Effects | Master Control
6.2

Scenes

Scenes
6.2
6.2.1

S1: Zero Out (Board Reset)

OUTPUT LEVEL
INPUTS AND BUSES
INPUT CHANNELS NULL
AUX BUSES NULL
FX A / FX B NULL
AUX IN A/B NULL
SOLO BUS NULL
MONITOR BUS NULL
HIPASS NOISE GATE
STATE: OFF STATE: OFF
THR 75 Hz THR
6.2.2

Creating a Scene

The StudioLive allows you to create and store a library of Scenes. A Scene is like
a snapshot of your mix. It stores each Fat Channel parameter for every input
and bus, as well as each fader's position, the aux and effects mixes, channel
mutes and solos, and the input source (analog input or USB playback stream).
Located at position S1 is a scene named Zero Out (Board Reset). This scene cannot
be overwritten and returns each parameter to its default setting. All you have to
do is lower the faders and return all trim knobs and output volume knobs (Solo
bus, FX A and FX B Output, Phones, and Monitor) to their lowest positions.
The StudioLive will be zeroed out as follows:
ASSIGN
MAINS
N/A
MAINS
MAINS
N/A
N/A
The Fat Channel will be restored to the same setting for every
input and output on your StudioLive. Each of the dynamics
processors and the three bands of the EQ will be turned off.
Their parameters will be set as follows:

FAT CHANNEL PARAMETERS

LIMIT
STATE: OFF
-84 dB
Power User Tip: Before beginning any new mixing situation, it is always recommended to
recall the Zero Out (Board Reset) Scene. This is the easiest way to ensure that there are no
lingering parameter settings that could cause you some trouble in your new mix.
Creating a Scene requires simply dialing in a mix that you would like to
use later and saving it. This has obvious benefits for both studio and live
sound. For example, in the studio, saving and recalling a Scene allows you
to move to another song or project and come back to the current mix later.
For live shows with multiple bands, you can set up custom mixes for each
band at sound check and recall the mix when that band goes onstage.
SETTINGS
PAN SOLO
C OFF
N/A OFF
N/A N/A
N/A N/A
N/A N/A
N/A N/A
COMPRESSOR EQ
STATE: OFF STATE:
THR 0 dB P/S
RAT 2:1 H/L
RESP MED FREQ
GAIN 0 dB GAIN
StudioLive™ 16.0.2 USB
Owner's Manual
MUTE STEREO LINK
OFF OFF
N/A OFF
OFF N/A
N/A N/A
N/A N/A
N/A N/A
LOW MID HIGH
OFF OFF OFF
PEAK N/A PEAK
N/A LOW N/A
130 Hz 96 Hz 5 kHz
0 dB 0 dB 0 dB
44