Transducer Adapter Cables - B&G Zeus Touch Installation Manual

Transducer adapter cables

For vessels with existing transducers that do not have the Navico blue 7 pin connector, there
are two adapter cables available to assist with installation.
For vessels that already have a transducer that was used with older Navico products that has 6
pin connector. Use 000-00022-001 6 pin to 7 pin transducer adapter cable.
These transducers will require the 10 k temp version of the transducer selected for transducer
type in Echo Installation. See the Echosounder Setup section on page 69 for further informa-
tion.
Blue 7 pin connector
6
5
1
7
2
4
3
Connector Pins
(Front View)
For other transducers that do not have Navico blue 7 Pin or 6 pin (above) connector that
require the connector to be removed. Use 000-10046-001 7 pin to bare wire adapter cable.
Not all transducers are compatible with Zeus Touch or BSM-1. Refer to the transducer type
selection list in the Echo Installation page to see if your transducer is mentioned for the
selected echo source. If not contact your B&G dealer or B&G Technical Support for assistance
with transducer compatibility.
Blue 7 pin connector
6 pin connector
5 1
6
2
4
3
Connector Pins
(Front View)
Wire color
Connector Pin
7. Shield Temp -
4. Yellow Temp +
3. Orange Speed volts
2. Blue
6. Shield Depth Gnd.
5. Black
1. Red
6
5
1
7
2
4
3
Connector Pins
(Front View)
External GPS | Zeus Touch installation manual
Function
Speed signal
Depth -
Depth +
| 23