Setting The Display Language In The System Installer Mode; Clearing/Installing The System Program - Omron NT31 Setup Manual

Operations in the System Installer Mode

6-5-1 Setting the Display Language in the System Installer Mode

6-5-2 Clearing/Installing the System Program

Reference:
The first setting made in the System Installer mode is to select whether the dis-
play language is to be English or Japanese.
Use this function when the system program of the NT31/NT31C has been cor-
rupted, or when installing a new system program.
S In order to install a system program, the system installer must also be installed
at the Support Tool. The system installer is an accessory with the Support Tool
(NT-ZJCAT1-EV4). When installing the Support Tool in a personal computer,
install the system installer also. For details on the method for installing the sys-
tem installer at the Support Tool side, and the operating procedure, refer to the
NT-series Support Tool Ver. 4.1 for Windows Operation Manual (V061-E1-j).
S When the system program is cleared by mistake, it becomes impossible to use
the NT31/NT31C at all. Check that the system installer is installed at the Sup-
port Tool side before deleting the program. However, note that the registered
screen data and memory switch settings are retained.
S It becomes possible to install the system program inside the memory unit auto-
matically by installing the memory unit at startup. (Refer to 3-5 Using a Memory
Unit (-Vj Versions).)
Clear/install the system program by following the menu operation from the Sys-
tem Installer mode menu shown below.
Select English or Japanese.
From here on, this manual assumes that
English has been selected here.
The System Installer mode menu is dis-
played.
If there is no system program or the system
program has been corrupted, the message
System Program not exist or incorrect. is
displayed at the bottom of the screen.
Section 6-5
149