Unlocking The 9200 - Orban Optimod-AM 9200 Operating Manual Addendum

A-6
OPTIMOD-AM 9200
Press the
E)
code.
Repeat step (E) to program the passcode with up to eight numbers.
F)
When you have finished programming your passcode, press the
G)
soft button to save it. Write your passcode down and keep it in a safe place.
2. Program local lockout.
SET MODEM
Hold down the
lockout and set the lockout delay time.

Unlocking the 9200

The 9200 front panel controls are locked out when the
is displayed.
To unlock the 9200:
Press the
A)
Turn the knob until the desired number appears.
B)
Press the
C)
code, if necessary.
Repeat step (C) to enter any additional numbers into the passcode, as necessary.
D)
When you have finished entering your passcode, press the
E)
soft button to unlock the front panel controls.
lowed, but spaces at the beginning of the passcode string can be used to dis-
able passcode protection (see below).
button. Then turn the knob to program the next number in the pass-
Next
REMOTE
INIT INTERFACE
LOCKOUT
You can program the lockout delay time (in minutes or hours) from 5 min-
utes to 8 hours, or off. This is time delay between the last access to a local
front panel control and when the front panel automatically locks itself out,
requiring entering the passcode to re-establish communication with the
9200.
On air: xxx
ENTER PASSCODE
Select character with knob
button. Then turn the knob to enter in the next number of the pass-
Next
VERSION 3.0 SOFTWARE ADDENDUM
SET
PASSCODE
soft button and turn the knob to enable/disable
soft button.
SAVE PASSCODE
LOCKOUT
Off
soft button
Enter Passcode
ENTER
PASSCODE
ENTER
PASSCODE
ENTER PASSCODE