Option A - Ethernet Adsl Internet Connection - NetComm V100LS Quick Start Manual

Option A - Ethernet ADSL Internet Connection

Connect the V100LS ATA to your ADSL modem as illustrated in the following diagram:
Note: In the above configuration you must ensure your ADSL modem has DHCP
enabled. Should your modem not support DHCP, please refer to Appendix C of
this manual for instructions on how to configure the V100 ATA.
1. Connect the Phone socket on the rear of your V100LS ATA to an analogue telephone using
a RJ-11 cable.
2. Connect the WAN socket on the rear of your V100LS ATA to the Ethernet port of your
ADSL modem or one of the LAN ports of your router/switch using a Category 5 cable.
Note: If you connect the WAN socket directly to your ADSL modem, you will not be
able to connect a computer. To connect multiple devices to your ADSL modem,
you will need a router or switch.
3. Connect the POWER socket on the rear of your V100LS ATA to the power adaptor
supplied and plug into a wall socket.
4. Everything required to connect to the VOIP network is preprogrammed into your V100LS
ATA. To make and receive calls, simply pick up the handset of your connected Analogue
Telephone and make the call. Your new MyNetFone VOIP number can be located on the
base of the V100LS ATA unit.
Note: If you have a Telstra telephone line you are still able to receive PSTN calls, but
you will need a microfilter and an additional analogue telephone. Do not under
any circumstanced connect the V100LS directly to a phone line.
YML739Rev1
www.netcomm.com.au
Figure 1 - Connecting the V100LS ATA to an ADSL Modem
V100LS User Guide
11