Using Your V100Ls; Making Outgoing Calls - NetComm V100LS Quick Start Manual

Voip telephone adaptor kit

Table of Contents

Using your V100LS

Once you have installed the V100LS ATA, and the WAN and POWER lights on the device are on,

you are ready to make your first call.

Note:

You can dial

your landline to contact MyNetFone customer service.

Everything required to connect to the VOIP network is preprogrammed into your V100LS ATA.

Your package also comes with an complimentary credit that allows you to begin making and

receiving calls immediately.

To ensure that your account is billed correctly, call 151 from your VoIP line or 1300 731 048 from a

landline. Alternatively, go to the section titled My Account in this manual for instructions on

Charging/Recharging your VoIP account.

Your MyNetFone service works just as a normal landline, but without the higher costs. Simply pick

up your analogue telephone handset (which has been connected to the V100LS ATA). You will be

able to hear a dialtone.

Note:

If you do not hear anything, please call MyNetFone customer support on

731 048

Dial the telephone number you wish to call. You will hear a ringing or busy tone through the

handset, just as you would on a standard landline phone, except that this call will be made using

your VOIP account.

For the latest rates and country codes, visit the http://www.myfone.com.au website.

Note:

If you have a standard landline telephone socket connected to the V100LS and

wish to use this account to make outgoing calls, press # before entering the

telephone number. The call will be made using your Telstra or Optus account.

YML739Rev1

www.netcomm.com.au

181

at any time using your VoIP line or

using your landline.

1300 731 048

using

1300

V100LS User Guide

Table of Contents