Removing And Replacing The Transceiver Pc Board Shield - Motorola L6 Service Manual

Disassembly

Removing and Replacing the Transceiver PC Board Shield

22
1. Remove the battery cover, battery, SIM, and antenna, as described in the
procedures.
2. Using a Torx Plus driver with a T5 bit, remove the 6 housing screws from the
phone. Set the screws aside for re-use (see Figure 10).
Figure 10. Removing and Replacing the Transceiver PC Board Shield.
3. Lift the metal shield away from the phone.
4. To replace, place the PC board shield onto the phone. Ensure screw holes are
aligned.
5. Insert and tighten the 6 T5 screws to a torque setting of 16 Ncm. Do not
overtighten.
6. Reassemble the antenna, SIM, battery, and battery cover as described in the
procedures.
October 14, 2005
Housing Screws
Housing Screws
L6
050781o
6809495A75-O