Disassembly; Removing And Replacing The Battery Cover - Motorola L6 Service Manual

Level 1 and 2 Service Manual

Disassembly

G
G

Removing and Replacing the Battery Cover

6809495A75-O
This section describes how to disassemble a L6 telephone. Tools and equipment
used are listed in Table 1.
Many of the integrated devices used in this phone are vulnerable to damage from
ESD. Ensure adequate static protection is in place when handling, shipping, and
servicing any internal components.
Avoid stressing the plastic in any way to avoid damage to either the plastic or
internal components.
1. Ensure the phone is turned off.
2. Press the battery cover latch on the bottom of the phone, and lift the battery
cover up from the phone and lift it off (see Figure 4).
Battery cover
Battery latch
Figure 4. Removing the Battery Cover
3. To replace, align the battery cover with the rear housing.
4. Place the battery cover on the rear housing and gently press the battery cover
until it snaps into place.
5. Ensure that the battery cover tap is tucked in below the RF cover.
October 14, 2005
Disassembly
050776o
17