Removing The Patch Sensor Unit; Preparation; Procedure - Canon Color imageRUNNER LBP5280 Service Manual

3
Disassembly/Assembly > Image Formation System > Removing the Patch Sensor Unit > Procedure
CAUTION:
Be sure to install the harness [1] to the guide [A] of the ITB Unit when installing.

Removing the Patch Sensor Unit

■ Preparation

1) Remove the ITB Unit.(Refer to page 3-62)
2) Remove the Right Cover.(Refer to page 3-16)
3) Remove the Operation Panel Unit.(Refer to page 3-36)
4) Remove the Rear Upper Cover (Left).(Refer to page 3-14)
5) Remove the Upper Cover.(Refer to page 3-19)
6) Remove the Left Cover.(Refer to page 3-17).
7) Remove the High-voltage Power Supply PCB.(Refer to page 3-50)
3 Disassembly/Assembly > Image Formation System > Removing the Patch Sensor Unit > Procedure
[1] [A]
F-3-148

■ Procedure

1) Free the harness [1] from the Harness Guide [A] and [B].
• 1 Connector [2]
[B]
2) Put the connector [1] facing up through the hole [C] of the guide, and remove the Patch
Sensor Unit [2].
[2]
3-65
[2]
[1] [A]
F-3-149
[1] [C]
F-3-150
3-65