Configuring "My Stuff - C. Crane CC WiFi Instruction Manual

<Factory Reset>
This option puts all settings back to their default, as they were when
the radio left the factory. If you perform a factory reset on your radio,
you will lose all your presets, clock settings, and wireless network
Configure Menu Options
connection settings.
To access the "Configure" menu follow these steps:
<Register>
This option will display a key that can be used to register the radio on
1. Briefly press the dial once to access the Primary Menu. You can
the Reciva Customer Portal.
also access the Primary Menu by pressing and holding the BACK
RadioMv Stream Network.
button.
<Clock Set Up>
The Primary Menu contains six options: STATIONS, PERSONAL
Use this option to set the time, date and clock format. See "Setting
the Time and Date" on page 15.
RADIO, MY STUFF, MEDIA PLAYER, CONFIGURE and ALARM
CLOCK.
<Backlight>
2. Turn the main dial until "Configure" shows in brackets — press the
Selecting this option will alter the Internet radio s backlight values.
dial to select. Turn the dial clockwise to access all the options.
1. After selecting the "Backlight" menu item, the radio will show three
backlight adjustment modes: "Inactive", "Active", and "Standby".
<Network Config>
These three settings are explained below:
This option is used for configuring your radio s network settings, net-
a) The "active" state is when the user is pressing buttons or
work parameters, and scanning for wireless networks. Once the radio
turning knobs.
has established a connection to the network, the information will be
b) The radio goes into its "inactive" state when there is no
saved to the radio for later use.
user activity for 30 seconds.
c) "Standby" is the state when the radio has been turned off.
<Version>
2. Rotate the dial to select the desired backlight mode — press the
Displays the electronic serial number and other information pertaining
dial to select.
to software and hardware installed on your internet radio.
3. The radio will display the current backlight value for the selected
mode. You can change this value by turning the dial to increase or
<Upgrade Firmware>
decrease it.
Use this option to download new control programing for the radio. If
there is new firmware available when this option is selected, then the
Configure Menu Options
<UPNP>
radio will prompt you to download.
Use this option to set a name for your radio that can be recognized by
Note: A firmware upgrade may take several minutes. DO NOT TURN
the UPNP Server.
OFF THE POWER TO YOUR RADIO WHEN UPGRADING FIRM-
Page 24
<WiFi Strength>
This option will give you your current WiFi signal strength between the
CC WiFi
radio and the router. Our experience shows that a signal strength of
20 to 30% is required for good reception.

Configuring "My Stuff"

Registering an account on Reciva s website:
1. Open Reciva s website, http://radios.reciva.com, from your
Internet browser on your computer.
18
2. Enter your Register Code, which can be found from the "Configure
> Register" menu on the radio. Refer to page 42 for the Menu
13-16.
CC WiFi
Page 23
CC WIFI