Name And Function Of Parts - JVC LWT0254-001B-H Instructions Manual

Introduction (continued)

Name and Function of Parts

Ceiling Mount (Terminal Side)
Safety Wire
A
Hang this wire to the Fastening Hook for Safety Wire
B [VIDEO OUT] Coaxial Cable Terminal
Output terminal of a composite video signal (1 V(p-p)) with
an output impedance of 75 K, to be connected to a
switcher, etc.
[AC24V H INPUT] AC 24 V Input Terminal
C
Connect to a AC 24 V power supply.
D Safety Wire Mounting Hole
To prevent the camera from falling down, pass the wire from
the ceiling slab or channel to this hole.
E [ALARM IN / OUT] Alarm Input/Output Terminals (J502)
Terminals for alarm input and output. (A pg. 17)
Pin No. Signal Name
1 Alarm Output +
2 Alarm Output -
3 Alarm Input
4 GND
^
5
I
A
B
C
S .
Displayed As
OUT +
OUT -
IN
GND
RESERVED
H
G
F
E
D
Locking Screw
F
For fastening the camera body. Ensure to fasten the
Camera Clamping Bracket
G [CONTROL] Control Signal Terminal (J501)
Connect this to the remote control unit (RM-P2580).
Pin No. Signal Name
1 TX +
2 TX -
3 RX +
4 RX -
H Cover
This is a protection cover. Cut a slit in the rubber cap
attached to the cover when wiring cables. When connecting
cables to the ceiling mount, ensure to do so by running the
cables through the Cover
I Cover Fastening Screw
This is used for fastening the Cover
mount.
To remove Cover H , do so by unfastening this screw.
EN
P using this screw.
Displayed As
H . (A pg. 16)
H and the ceiling
7