JVC LST0728-001C Instructions Manual page 89

B
IP Lease Parameter
● 192.168.0.100
Start Address
● 20Units
Unit
● 255.255.255.0
Subnet Mask
● 192.168.0.254
Gateway
DNS Server
● 192.168.0.253
Primary
● 192.168.0.252
Secondry
Domain Name
● No
C
Lease Time Limit
● Only Camera
D
Client
E
IP Information
F
Reserve MAC
Address
G
OK/Cancel
For specifying the first IP address to be assigned to the
cameras.
For selecting the number of IP addresses to be assigned to the
cameras. The selected number of IP addresses will be
1Unit to 99Units
assigned starting from the first IP address.
For specifying the subnet mask for the cameras.
For specifying the gateway for the cameras.
For specifying the primary DNS for the cameras.
For specifying the secondary DNS for the cameras.
^ For specifying the domain name for the cameras.
For specifying the valid period of the IP address assigned to
the cameras.
Yes
If AYesB is selected, you can set the lease time in units of hours.
(Setting value: 1 hour to 99 hours)
For selecting whether to apply restrictions on the device when
assigning the IP address. If AOnly CameraB is selected, IP
Any Client
address will only be assigned to the corresponding camera. If
AAny ClientB is selected, IP address will be assigned to all
devices.
^ The [IP Information] list contains information on the [IP
address] of the automatically detected camera, MAC address,
number of video CH, manufacturer, and model.
Click [Auto Detect] to start auto detect and display the result.
The camera at the top of the list is used with priority.
You can click the Sort button to sort the order of detected
cameras.
There are five types of sort buttons, including Sort by [IP], Sort
by [MAC], Sort by [CH], Sort by [MAKER], and Sort by
[MODEL] buttons.
Select the detected cameras, followed by clicking the [Up] or
[Down] button to change the order of the cameras.
Deselect the check box of any camera that you are not using.
After doing so, click [Entry]-[OK]. The [Autodetect Device]
screen appears. After entering the camera password, the
[Camera Record Setting] screen appears. Clicking [Close]
automatically creates a Default View. To save this view, change
its name.
Memo :
● When multicast packets are configured such that they do not
pass through the network equipment, such as a switching
hub, the Auto Detect of the camera may not function
properly.
● [Analog-in] is the built-in analog input of VR-N900U. The
highest priority is given to the number of CH used during
configuration. (VR-N900U)
● Devices other than the cameras may appear in the list.
Uncheck the boxes of these devices.
Note :
● Deselecting the [Analog-in] check box disables the [ALARM
IN 1 to 4] signal input terminal at the rear of the unit.
(VR-N900U)
^
Configure the [Reserve MAC Address] if you want to assign a
specific IP address to the cameras. A specific IP address is
always mapped to a MAC address. Enter a value in the [MAC]
and [IP] fields, and click [Add] to set the addresses. To cancel
the setting, select a displayed MAC and IP address, and click
[Del].
^ Clicking this button closes the setup screen, and starts/stops
the IP address assignment function according to the settings.
^
^
^
A Page 113
A Page 23
^
^
81