Table of Contents
Advertisement
Basic Operation
Opening the Main Menu
The following are procedures to open the main menu, which is used
for specifying various settings.
Note :
● The input ports do not operate when the main menu is
displayed. Inputs such as alarms will also be ignored when the
main menu is displayed.
[Input ports] (A Page 15) (VR-N1600U/E)
[Input ports] (A Page 19) (VR-N900U)
[SELECT] Button
[2/D] Button
WARNING
LIVE/BROWSE
OPERATE
ALARM
HDD
SELECT
LOCK
REC CONTROL
PTZ/PRESET
FUNCTION
SERIAL
CANCEL
ZOOM OUT
ZOOM IN
ENTER
[FUNCTION]
Button
[16/ENTER] Button
[13/CANCEL]
Button
[REC CONTROL]
[10/0/E] Button
Button
[SELECT] Button
[2/D] Button
[FUNCTION]
Button
[ZOOM IN/ENTER] Button
[ZOOM OUT/
CANCEL] Button
[REC CONTROL]
[8/E] Button
Button
1
Press and hold the [REC/STOP] button for at
least 2 seconds
● Recording stops.
Memo :
● When in the recording control mode, press and hold the [REC
CONTROL] button for at least 2 seconds to switch the recording
control mode off and stop recording.
● For details on the recording mode, refer to [Recording Modes]
(A Page 52).
2
Press and hold the [FUNCTION] button, and
press the [REC CONTROL] button at the same
time
● The main menu appears.
32
VR-N1600U/E
REV
SEARCH
KEY
ALARM CLEAR
REC/STOP
STOP(PB)
PLAY
[REC/STOP]
Button
[SKIP] Button
VR-N900U
[REC/STOP] Button
[SKIP] Button
● Select a menu with the [2/D] or [10/0/E](8/E) button and
press the [16/ENTER](ZOOM IN/ENTER) button to open
the selected setting screen.
The same operation can be done using the [SKIP] button.
[Main Menu](VR-N1600U/E)
FWD
SKIP
[Main Menu](VR-N900U)
3
Select an item
● Select the required item using the [2/D] or [10/0/E](8/E)
button and specify the settings.
● Press the [16/ENTER](ZOOM IN/ENTER) button to save
the settings, and press the [13/CANCEL](ZOOM OUT/
CANCEL) button to close the screen and return to the
main menu.
Memo :
● To exit the main menu, press the [13/CANCEL](ZOOM OUT/
CANCEL) button.
Note :
● In some occasions, the NVR Viewer may appear instead when
you try to display the main menu while the NVR Viewer is
running. In this case, press the [LIVE/BROWSE] button on the
front panel and perform the operation to display the main menu
again.
For details on the main menu settings, refer to
[Main Menu List] (A Page 68).
Advertisement
Table of Contents
