Installing optional trays
Order of installation
CAUTION—TIPPING HAZARD: Floor-mounted configurations require additional furniture for stability. You must
use either a printer stand or printer base if you are using a high-capacity input tray, a duplex unit and an input
option, or more than one input option. If you purchased a multifunction printer (MFP) that scans, copies, and faxes,
you may need additional furniture. For more information, contact the place where you purchased the printer.
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the wall
outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and
unplug any cables going into the printer.
CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or more trained
personnel to lift it safely.
Install the printer and any optional trays or finishers you have purchased in the following order:
Using a 1-tray module
•
Optional 520-sheet tray (Tray 2)
•
Printer
•
2,000-sheet high-capacity feeder
•
Finisher
Using a 3-tray module
•
3-tray module
•
Printer
•
2,000-sheet high-capacity feeder
•
Finisher
Using a tandem-tray module
•
Tandem-tray module
•
Printer
•
2,000-sheet high-capacity feeder
•
Finisher
For information on installing a 1-tray module, 3-tray module, tandem-tray module, high-capacity feeder, or any of the
finishers, see the setup documentation that came with the option.
Installing optional trays
The printer supports the following optional trays:
•
1-tray module
•
3-tray module
Additional printer setup
48