Raypak 131 Service Instructions Manual page 46

Right Hand Side Panel
1. Remove the Cord Set. Refer to „Cord Set‟ procedure on page 55.
2. Remove the Display Panel. Follow steps 1-3 of the „Display Panel Removal‟ procedure
on page 43.
3. Remove the Top Panel. Follow steps 3 & 4 of the „Top Panel‟ procedure on page 44.
4. Remove the Upper In/Out Header Panel. Follow steps 3 & 4 of the „Upper In/Out
Header Panel‟ procedure on page 44.
5. Remove the Lower In/Out Header Panel. Follow steps 3 & 4 of the „Lower In/Out
Header Panel‟ procedure on page 44.
6. Remove the 2 screws retaining the front & rear Upper Grille panels to the right hand
side panel.
7. Remove the screws retaining the Diverter Draft Intake Panel and Flue Diverter
Assembly (3 in each panel) to the right hand side panel.
8. Isolate the gas supply and disconnect the pool heater inlet gas connection by
unscrewing union in an anticlockwise direction.
9. Remove the screw from the front and rear edge of the right hand side panel.
10. Remove the 3 screws along the bottom edge of the right hand side panel.
11. Remove the side Panel. NOTE: Each Upper Grille has a tab which slots into the side
panel. To disengage the tab, slide the panel off the tabs while keeping the panel
upright.
12. Reassemble in reverse order of above.
13. Test for gas leaks using soapy water solution.
Left Hand Side Panel
1. Remove the Display Panel. Follow steps 1-3 of the „Display Panel Removal‟ procedure
on page 43.
2. Remove the Top Panel. Follow steps 3 & 4 of the „Top Panel‟ procedure on page 44.
3. Remove the Upper In/Out Header Panel. Follow steps 3 & 4 of the „Upper In/Out
Header Panel‟ procedure on page 44.
4. Remove the Lower In/Out Header Panel. Follow steps 3 & 4 of the „Lower In/Out
Header Panel‟ procedure on page 44.
5. Remove the 2 screws retaining the front & rear Upper Grille panels to the left hand
side panel.
6. Remove the screws retaining the Diverter Draft Intake Panel and Flue Diverter
Assembly (3 in each panel) to the left hand side panel.
7. Remove the screw on the front and rear edge of the left hand side panel.
8. Remove the 3 screws along the bottom edge of the left hand side panel.
9. Remove the side panel. NOTE: Each Upper Grille has a tab which slots into the side
panel. To disengage the tab, slide the panel off the tabs while keeping the panel
upright.
TM018 Raypak 131 Type A Pool & Spa Heaters REV: A
D.O.I: 8/04/2009
This document is stored and maintained electronically by
46
Service. All printed copies not bearing this statement in RED are deemed "uncontrolled"