Silvercrest SAB 160 A1 Operating Instructions Manual page 12

GB
IE
Antenna power connection
Connection of an external amplifi er
Connection of an external subwoofer
Connecting the microphone unit
10
To connect the device to two speakers use only the cables for the front speakers.
NOTICE
► Make sure that a permanent positive connection is applied to the station
memory of connection 4 in the ISO block A.
► In some automobile models the standard confi guration of the connections
[4] and [7] in ISO block A are interchanged at the factory. If this is the
case the station memory can be lost. To correct this, the connections 7
(Ignition positive) and 4 (Permanent positive) in the ISO Block A must be
swapped.
► You can connect an external amplifi er to the audio cinch output. For this
follow the operating instructions for the external amplifi er.
IMPORTANT
Possible damage to the device!
► Never attach the antenna power connection with the antenna's motor
power cable.
The connection for the antenna power is available for a relay controlled antenna.
The relay then automatically extends the antenna when the device is switched
on. When switched off the antenna retracts. This connection can also be used to
control an external amplifi er. For exact connection information please consult the
amplifi er's operating instructions.
For the connection of an external amplifi er use the audio cinch output LINE OUT
For this follow the operating instructions for the external amplifi er.
For the connection of an external subwoofer use the yellow cinch connector
SUBWOOFER . For this follow the operating instructions for the external
38
subwoofer.
For connection of the microphone unit use the microphone unit socket
Installation
40 .
39 .
SAB 160 A1