KVH Industries TracVision TV1 Installation Manual page 33

A
Continued
Wire the IP AutoSwitch
The wiring of the IP AutoSwitch depends on the
specific configuration. Refer to the wiring
diagrams provided in
TV Wiring" on page
general wiring steps below:
a. Disconnect the RF input cable from the
receiver and connect it to the "RF In" jack on
the IP AutoSwitch. Then tighten to 15 in.-lbs
of torque.
b. Connect the supplied 2 ft (60 cm) RF cable
from the "To Receiver" port on the IP
AutoSwitch to the receiver's satellite input
and tighten to 15 in.-lbs of torque.
c. Using the supplied Ethernet cable, connect
the "Network" port of the IP AutoSwitch to
the onboard network. If a network is not
available, install a router as shown in
Figure 55.
d. If not already connected, connect the TV-Hub
to the onboard network (see Figure 55).
e. Using the supplied Velcro strip, secure the
IP AutoSwitch to the mounting surface.
32
Installing an IP AutoSwitch
"DISH Network and Bell
18, while following the
Figure 55: IP AutoSwitch Connections
RF Input**
RF In
Network To Network*
IP AutoSwitch
To Receiver
Satellite In
** Varies depending on your system configuration
* Network Connections
Connect the TV-Hub and IP AutoSwitch(es) to your
onboard network. If you do not have a network, install
a router or router and switch as shown below.
TV-Hub
1 2 Ethernet 3 4 Internet Reset
Connect up to 3 IP AutoSwitches
OR
To TV-Hub
1 2 Ethernet 3 4 Internet Reset
Connect up to 2 IP AutoSwitches
8 7 6 5 4 3 2
POE
Connect up to 7 IP AutoSwitches
Receiver
AC Power
Router
12VDC
POWER
AC Power
Router
12VDC
POWER
AC Power
Switch
1
+
48V
AC Power